Glossary entry (derived from question below)
английский term or phrase:
cutting window
русский translation:
окно пиления
Added to glossary by
Vitals
Mar 1, 2011 11:13
13 yrs ago
1 viewer *
английский term
cutting window
английский => русский
Техника
Лесная и деревообрабатывающая промышленность
форвардеры/ха
Инструкция харвестерной головки. Фраза встречается в таких вот контекстах: http://www.machinerie.com/ManuelOperateur/patu/tete/MOTOMIT_...
* Sound signal, when a block of this product type has stopped inside the cutting window.
* Cutting window
Allowed lower and upper limits for the cutting tolerance per product type.
E.g. preset SPRUCE LOG 400cm
Cutting window : Bucking length
0 – 50 mm = 400 – 405 cm
-30 – 30 mm = 397 – 403 cm )*
30 – 80 mm = 403 – 408 cm
)* Don’t forget the minus sign, when needed. If both of the limits are set to same value, the cutting window is 0
mm and it is impossible for the head to stop at that length.
* Difference between the nominal length and the cut length should be made by shifting the cutting window wholly to the positive side, for example from +120mm to +170mm.
* If the stem has not stopped inside the cutting window, the computer will give feeding pulses, ‘control pulses’ to
feed the stem into the cutting window.
Спасибо заранее.
* Sound signal, when a block of this product type has stopped inside the cutting window.
* Cutting window
Allowed lower and upper limits for the cutting tolerance per product type.
E.g. preset SPRUCE LOG 400cm
Cutting window : Bucking length
0 – 50 mm = 400 – 405 cm
-30 – 30 mm = 397 – 403 cm )*
30 – 80 mm = 403 – 408 cm
)* Don’t forget the minus sign, when needed. If both of the limits are set to same value, the cutting window is 0
mm and it is impossible for the head to stop at that length.
* Difference between the nominal length and the cut length should be made by shifting the cutting window wholly to the positive side, for example from +120mm to +170mm.
* If the stem has not stopped inside the cutting window, the computer will give feeding pulses, ‘control pulses’ to
feed the stem into the cutting window.
Спасибо заранее.
Proposed translations
(русский)
3 | окно пиления | Enote |
3 | Режущее устройство (окно) | Sona Petrosyan |
3 | отверстие харвестерной головки | Polina Stroganova |
Proposed translations
1 час
Selected
окно пиления
имхо, можно дословно перевести - это где ходит пила (и перепиливает ствол, если он туда попадет)
или вместо окна можно написать интервал, участок.
но вроде и окно нормально (пилится от и до)
или вместо окна можно написать интервал, участок.
но вроде и окно нормально (пилится от и до)
4 KudoZ points awarded for this answer.
Comment: "спасибо!"
17 мин
1 час
отверстие харвестерной головки
...
Something went wrong...